What part would make your car not pass smog regulations because of hydrocarbons?

Ignition Problems Ignition timing issues may cause a failed smog test, either through a functional failure or through increased release of hydrocarbons. ... Ignition components include ignition coils, distributor cap, rotor and spark plugs.

1. What would cause high hydrocarbons for emissions test?
2. How can I lower my hydrocarbons smog?
3. What are hydrocarbon emissions?
4. What does high hydrocarbon mean?
5. What causes high levels of hydrocarbons?
6. What can I put in my gas tank to pass emissions?
7. Can spark plugs affect emissions?
8. What are the causes for hydrocarbon emission from SI engine?
9. How are hydrocarbons formed in cars?
10. What is no ppm on smog check?
11. What are the effects of hydrocarbons to human health and environment?
12. How do I reduce NOx in my car?
13. What is HC ppm in the smog test?

What would cause high hydrocarbons for emissions test?

There are still many possible causes of high hydrocarbons, most of which are either internal engine problems or tough-to-detect induction system problems such as valve deposits or a leaking EGR valve. On fuel-injected vehicles, poor fuel atomization is a common cause of HC problems.

How can I lower my hydrocarbons smog?

On a precomputer carbureted car, one way to get under the HC and CO limits is to retard the ignition timing. This will slow the idle and provide a longer, hotter burn. Then, bring the idle speed back up to specs with the throttle stop screw or idle stop solenoid, which will admit more air.

What are hydrocarbon emissions?

Hydrocarbons, or more appropriately organic emissions, are the consequence of incomplete combustion of the hydrocarbon fuel. The level of unburned hydrocarbons (HC) in the exhaust gases of gasoline fueled spark-ignition engines is typically 1 to 2% of the fuel: in diesels it is much less.

What does high hydrocarbon mean?

Hydrocarbons are basically raw fuel, otherwise known as Gasoline. High Hydrocarbon (HC) emissions are almost always a sign of poor fuel ignition. However, it's not always that the engine's ignition system is responsible for high Hydrocarbon emissions.

What causes high levels of hydrocarbons?

Contamination of hydrocarbon occurs due to toxic organic substances, petroleum, and pesticides which is a serious concern for the environment.

What can I put in my gas tank to pass emissions?

So if you're looking for help passing an emissions test, or you just want a better running car or truck, try this: Add two cans of Sea Foam Motor Treatment or Sea Foam High Mileage (for cars and trucks with over 75,000 miles) to a low tank of fuel and drive normally for about 20 miles.

Can spark plugs affect emissions?

Change your spark plugs and check your spark plug wires: Worn or fouled spark plugs, as well as worn spark plug wires can result in less-than-stellar results on your emissions test. ... And it's the only spark plug recognized by the EPA (Environmental Protection Agency) as an emissions control device.

What are the causes for hydrocarbon emission from SI engine?

Abstract. Unburned hydrocarbon (HC) emission results because part of the fuel inducted into the engine escapes combustion. HC emission is dependent on many mechanisms such as adsorption and desorption of fuel in oil layer, flame quenching, fuel escaping into crevices and accumulation of fuel in engine deposits, etc.

How are hydrocarbons formed in cars?

Motor vehicle fuel contains hydrocarbons, which are its primary source of energy. Any hydrocarbons emitted from a vehicle indicate unused fuel, which results from incomplete fuel combustion. ... The danger in hydrocarbon emission is in its combination with sunlight and nitrogen, which forms ozone.

What is no ppm on smog check?

Nitrogen Oxide or NO is created when an engine's combustion chamber temperature reaches over 2500F.

What are the effects of hydrocarbons to human health and environment?

As major components of oil, natural gas and pesticides, these substances contribute to the greenhouse effect and climate change, deplete the ozone, reduce photosynthetic ability of plants, and increase occurrences of cancer and respiratory disorders in humans.

How do I reduce NOx in my car?

Fuel switching is the simplest and potentially the most economical way to reduce NOx emissions. Fuel-bound NOx formation is most effectively reduced by switching to a fuel with reduced nitrogen content. No. 6 fuel oil or another residual fuel, having relatively high nitrogen content, can be replaced with No.

What is HC ppm in the smog test?

Find "HC PPM" within the tailpipe section. You read this as hydrocarbon parts per million, and it means the number of hydrocarbon molecules for every million molecules emitted through the exhaust.