How is it that my wheel keeps breaking the bolts from the hub every 4months ive changed the hub and bolts five times and even decided to change the rims and still breaking?

1. Why does my hub assembly keep going bad?
2. What causes wheel hub failure?
3. How long should wheel hubs last?
4. How often should wheel hubs be replaced?
5. Why do my wheel studs keep breaking?
6. Why do wheel bolts break?
7. Can you drive with a bad wheel hub?
8. Can a bad wheel bearing cause traction control light to come on?
9. Should you replace wheel hubs in pairs?
10. How much does a wheel bearing cost?
11. Can I just replace the wheel bearing and not the Hub?
12. How long can you drive with bad wheel bearings?
13. Why would a wheel hub need to be replaced?

Why does my hub assembly keep going bad?

The main reasons that a wheel bearing fails are: ... Driving conditions – driving through deep water or mud can cause your wheel bearings to fail. Water, mud or other contaminants such as dust or road salt could get past the seals and enter the bearing, polluting the grease and wearing away the bearings.

What causes wheel hub failure?

There are four primary causes of hub failures. They are lack of lubrication, overloading the vehicle, installing the axle nut too tight, or installing the axle nut too loose. Usually, hub failures are progressive and will produce some evidence of the impending failure.

How long should wheel hubs last?

The wheel hub assemblies on a car are intended to last for about 100,000 miles. While this can happen, there are usually things that will happen before this milestone hits that will compromise the assemblies and the way they function.

How often should wheel hubs be replaced?

They make the world go 'round. Most serviceable wheel bearings need maintenance every 25,000 to 30,000 miles, or during every brake service. But, the average life of a sealed wheel bearing and hub assembly is about 85,000 to 100,000 miles, without the opportunity for a technician to repack the bearings.

Why do my wheel studs keep breaking?

The most common cause of a bad or failing wheel stud is due to improper installation by tire service technicians, over torquing of lug nuts, or lug nuts that are not tight enough. ... When a stud goes bad, it snaps off the hub and creates a serious safety situation.

Why do wheel bolts break?

However, because the wheel stud is exposed to the elements and takes on tremendous daily stress, there are other issues that can cause these parts to wear out or break. Improper installation, over torquing of lug nuts, or under tightening of lug nuts can all cause a wheel stud to fail.

Can you drive with a bad wheel hub?

Q: Is it safe to drive with a bad wheel bearing? A: No. It can, in fact, be very dangerous to drive if one of your bearings is worn out, especially since it may cause the wheel to stop while driving. Additionally, a damaged wheel bearing puts a lot of stress on the hub, the CV joint, and the transmission itself.

Can a bad wheel bearing cause traction control light to come on?

On many modern cars, a bad wheel bearing will trigger a warning light. The ABS or traction control warnings will often illuminate, since a bad bearing will trip the system to deactivate.

Should you replace wheel hubs in pairs?

You should replace your hub assembly and wheel bearings. Here's how to replace wheel bearings. Even if only one side is bad, it makes sense to replace them in pairs. The “good” side is likely to cause problems in a relatively short time.

How much does a wheel bearing cost?

The labor cost for a wheel bearing replacement also varies and will generally cost anywhere from $60 to $300. It should take between 1 to 1.5 labor hours to change the wheel bearing. In total, the cost to replace a wheel bearing is around $150 to $800.

Can I just replace the wheel bearing and not the Hub?

On some cars, you can just replace the bearing and call it a day. On others, the hub assembly must be removed and replaced. The most difficult type involves removing the hub assembly and setting it in a press. If you're not sure what type of wheel hub assembly you have, stop by or give your local Pep Boys store a call.

How long can you drive with bad wheel bearings?

To avoid this situation, it is recommended to drive at the slower speed so that your wheel stays in action a few more hours. SO, while thinking how long can you drive on a bad bearing? You should not go more than 1000 miles as it might result in some bigger issue.

Why would a wheel hub need to be replaced?

A wheel bearing needs to be replaced only if it's damaged or worn out. What are the symptoms of a bad wheel bearing? The most common sign is when an internal damage causes a wheel bearing to produce a humming noise. ... Sometimes a loose wheel bearing can cause a squeaking or growling noise.