What does fault code 5587 mean in Allison transmission model MD 3060 P?

1. How do you reset a Allison Transmission code?
2. How do I reset my Allison push button transmission?
3. How do you check an Allison transmission code?
4. How do I reset my Allison transmission oil filter?
5. How often should Allison transmission fluid be changed?
6. What kind of transmission fluid does an Allison Transmission take?
7. How do I reset my TCM Allison Transmission?
8. How do I reset my transmission fluid light?

How do you reset a Allison Transmission code?

Press and hold the MODE button for 10 seconds to clear both active and inactive codes. Sensor and Diagnostics operation of your Allison Automatic, and is not intended to replace your Operator's Manual.

How do I reset my Allison push button transmission?

Note that the Transmission Health Monitor can only be reset using the Allison DOC software after a clutch system issue has been corrected. For either a pushbutton or bump lever shift selector, press and hold the Mode button for approximately 10 seconds while you are still in the Oil Life Monitor mode.

How do you check an Allison transmission code?

Using a lever shift selector, press the DIAGNOSTICS button two times. To read diagnostic codes in the digital display: Diagnostic codes will appear two characters at a time on a pushbutton or lever selector. The Code Position (d1) is the first item displayed, followed by the Diagnostic Trouble Code (DTC),** P, 07, 22.

How do I reset my Allison transmission oil filter?

One way to reset oil life involves the Mode button on some shifter designs. After accessing the oil life display, push and hold the Mode button on the shifter for 10 seconds. Another method is to turn the key on, engine off, and then move the shifter between N-D-N-D-N-R-N.

How often should Allison transmission fluid be changed?

If an odometer is used to determine when to change the transmission fluid and filters, this specific vehicle would change the fluid every 42,000 miles (66 000 km) and filters every 21,000 miles (33 000 km).

What kind of transmission fluid does an Allison Transmission take?

Mobil Delvac 1 ATF is a fully synthetic fluid recommended by Allison Transmission, Inc. and approved against the Allison TES-295 and TES-468 Specifications. The fluid is designed to meet the demanding requirements of modern heavy-duty automatic transmissions.

How do I reset my TCM Allison Transmission?

To reset the TCM, I turn the key to the ON position, step on the accelerator pedal for 10 seconds, turn off the engine, release the accelerator pedal and wait 5 minutes for the engine to restart.

How do I reset my transmission fluid light?

You can reset this by turning the key in the ignition over to the 'on' position and simultaneously press the gas pedal three times. Now, put the car off and start it fully. When the engine runs, it should trigger a reset of this warning.